Materials Managing Electrical power UNIT 1
This electrical power unit is designed for that fork lift field, consisting of remarkably efficient gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down motion are managed by the lever of your guide release valve, which is equipped with an electrical switch to activate the motor. The lowing velocity is managed through the pressure compensated flow handle valve.
one. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all the hydraulic parts concerned in advance of set up of the power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which ought to also be clean and free of charge of impurities, N46 hydraulic oil is advisable .
4. Oil shifting is needed after the preliminary one hundred operation hrs, afterwards once every single 3000 hours.
five. The power unit shown is intended to be mounted horizontally.
Material Managing Electrical power UNIT 2
This energy unit features electrical power up gravity down circuit. Activate the get started solenoid to begin the motor to lift the machine. The lowing movement is activated through the solenoid valve together with the reducing velocity controlled by the pressure compensated movement management valve. Solutions of this series is often broadly used in the market of logistic units like fork lift, mini lift table, and so on.
one. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all the hydraulic components concerned prior to mounting the power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which should also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
4. Oil transforming is needed just after the preliminary one hundred operation hrs,afterwards once each 3000 hrs.
5. The electrical power unit ought to be mounted horizontally.