The EP Greenhouse geared motor is a compact and lightweight reduction gear motor with a limit switch system that is ideal for assembly of a locally available electric motor. The gear reducer can be used in manually-controlled or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP gear reducer is certainly rainproof and windproof. The reducer includes a high protection course (IP65) and can be utilized in an ambient temperature of 0-60 °C.
The low-noise gear reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny means that the drive shaft is certainly locked when the decrease reducer is not running. The fully sealed reduction gear motor has an growth chamber with a diaphragm to keep carefully the gear oil at a minimal pressure under all situations, even at high temperatures. Thanks to the usage of an growth chamber, the gear driver could be installed in any position. There are no limitations, because there is no need for a bleed connect. The sealed reduction gearbox keeps the apparatus essential oil of the gear reducer in optimal condition because of its entire operating life time. The reducer is suitable for discontinuous use, operating class s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gearbox has an FT85 motor assembly flange, on to which a suitable IEC standard motor can certainly be installed (EN 
50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit switch system is installed in an included chamber and can be enclosed by an impact-resistant plastic cover. The limit switch system is obtainable and easy to adjust. The limit switch system’s optimum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The geared motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The geared motor for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).