DUMP TRAILER Energy UNIT-DOUBLE ACTING
This electrical power unit has a power up power down circuit with load holding on each A & B ports. A stress compensatred movement manage might be added to circuit to regulate the decent speed of the cylinder.
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic elements concerned ahead of installation of the energy unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst, which should really also be clean and no cost of impurities. N46 hydraulic oil is encouraged.
4. The energy unit needs to be mounted horizontally.
5. Check the oil degree from the tank after the first working of the power unit.
six. Oil transforming is needed right after the original one hundred operation hours, afterwards the moment each and every 3000 hrs.
DUMP TRAILER Energy UNIT- SINGLE ACTING
This power unit features a electrical power up gravity down circuit. Start out the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve could be presented if necessary. Also a pressure compen sated flow manage is often extra for the circuit to control the descent pace with the cylinder.
Remark: Please check with our revenue engineer for your distinctive pump displacement, motor power or tank capacity.
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
2. Clean all the hydraulic components concerned ahead of set up of the electrical power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which really should also be clean and free of impurities.N46 hydraulic oil is recommended.
4. The power unit must be mounted horizontally.
five. Check the oil degree inside the tank after the initial operating of the power unit.
6. Oil altering is needed following the first a hundred operation hours, afterwards when every single 3000 hours.