SNOW PLOW Energy UNIT

Basic Description
Consisting of the strain balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this electrical power unit is designed to operate material handling equipment. The decreasing motion is achived by the solenoid valve with all the decreasing speed controlled by an adjustable needle valve. The left and appropriate functions are outfitted by using a dual pilot operated verify valve and cross-over relief valves.
Remark: Please talk to our revenue engineer for your distinctive pump displacement, motor energy or tank capability.
Specific Notes
one. This power unit is of S3 duty cycle, i.e.,non-continuous operation,thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic components concerned before installation of the electrical power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which should also be clean and free of charge of impurities.N46 hydraulic oil is encouraged.
four. This energy unit should be mounted horizontal.
5. Check the oil degree from the tank following the very first get started from the energy unit.
six. Oil altering is needed after the initial 100 operation hours, afterwards after every single 3000 hrs.

TAGs:

China Timing Pulley

As one of the leading timing pulley manufacturers, suppliers, and exporters of mechanical products, We offer timing pulleys and many other products.

Please contact us for details.

Mail: [email protected]

Manufacturer supplier exporter of China timing pulley.

Recent Posts

As one of the leading China Timing Pulley manufacturers, mechanical product suppliers, and exporters, we supply timing pulley and many other products. Find China timing pulley Manufacturers and Suppliers. Choose from quality China timing pulley manufacturers, suppliers, and exporters on china-timing-pulley.com.
The above information is only for knowledge sharing, product, and manufacturer introduction. For non-commercial purposes. All content is from the web. The article is our opinion. If there is any copyright infringement or finds objectionable information, please contact us, and we will delete it immediately. Address:2-25 S Clark St, Denver, America. The use of original equipment manufacturer (OEM) part numbers or trademarks is for informational purposes only, describing product use and compatibility and replacing damaged original equipment parts. Our company and the replacement parts listed here are not sponsored, approved, or manufactured by an OEM.edited by lyl.