Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is intended exclusively for that modest lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit continues to be broadly made use of during the industry of logistic units including minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is managed through the solenoid valve with the speed controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This energy unit is created solely to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve along with the pace controlled through the adjustable needle valve. Once the lift rises to a high positoin, but the electrical power supply is minimize, the decreasing motion is managed through the guide override perform.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This power unit is created solely for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve along with the pace managed by a strain compensated flow management valve.
Power UNITS FOR LIFT TABLE 4
General Description
This energy unit is intended solely for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is minimize, the decreasing motion is managed from the guide override function.
Exclusive Notes
one. This electrical power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean the many hydraulic elements concerned before installation of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which should really also be clean and free of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is needed right after the original one hundred operation hrs,afterwards the moment each and every 3000 hrs.
five. The electrical power unit shown is built to be mounted vertically.

TAGs:

China Timing Pulley

As one of the leading timing pulley manufacturers, suppliers, and exporters of mechanical products, We offer timing pulleys and many other products.

Please contact us for details.

Mail: [email protected]

Manufacturer supplier exporter of China timing pulley.

Recent Posts

As one of the leading China Timing Pulley manufacturers, mechanical product suppliers, and exporters, we supply timing pulley and many other products. Find China timing pulley Manufacturers and Suppliers. Choose from quality China timing pulley manufacturers, suppliers, and exporters on china-timing-pulley.com.
The above information is only for knowledge sharing, product, and manufacturer introduction. For non-commercial purposes. All content is from the web. The article is our opinion. If there is any copyright infringement or finds objectionable information, please contact us, and we will delete it immediately. Address:2-25 S Clark St, Denver, America. The use of original equipment manufacturer (OEM) part numbers or trademarks is for informational purposes only, describing product use and compatibility and replacing damaged original equipment parts. Our company and the replacement parts listed here are not sponsored, approved, or manufactured by an OEM.edited by lyl.